思科路由器如何设置思科IOS防火墙

路由器故障 2015-09-30 0 3253字
- N +

实验步骤:

    第一步:在R1 、 R2 、 R3上的预配置

    r1(config)#int e0/0

    r1(config-if)#ip add 172.16.1.1 255.255.255.0< BR>    r1(config-if)#no sh

    r1(config)#ip route 0.0.0.0 0.0.0.0 172.16.1.2配置静态路由

    r1(config)#^Z

 

    r2(config)#int e0/0

    r2(config-if)#ip add 172.16.1.2 255.255.255.0

    r2(config-if)#no sh

    r2(config-if)#int e2/0

    r2(config-if)#ip add 192.168.1.2 255.255.255.0

    r2(config-if)#no sh

 

    r3(config)#int e2/0

    r3(config-if)#ip add 192.168.1.3 255.255.255.0

    r3(config-if)#no sh

 

    r3(config)#ip route 0.0.0.0 0.0.0.0 192.168.1.2 配置静态路由

    r3(config)#^Z

 

    r3(config)#li vty 0 4

    r3(config-line)#pass

    r3(config-line)#password cisco

    r3(config-line)#exit

第二步:

    在R2上配置zhang

    r2#conf t

    Enter configuration commands, one per line. End with CNTL/Z.

    r2(config)#ip inspect name zhang tcp   检查TCP

    r2(config)#ip inspect name zhang udp   检查udp

    r2(config)#ip inspect udp idle-time 60 检查udp 的时间是60S

    r2(config)#ip inspect name zhang icmp timeout 5 超时时间是5S

    r2(config)#ip inspect name zhang http alert off 控制HTTP

    r2(config)#

    r2(config)#int e0/0

    r2(config-if)#ip inspect zhang in   在e0/0接口检查流量是否满足以上所定义过的任何一条

    r2(config-if)#exit

 

    r2(config)#acce 100 deny ip any any log 做ACL拒绝IP的任何包通过

    r2(config)#int e2/0

    r2(config-if)#ip acce 100 in               将ACL要用到e2/0的进接口上

    第三步: 从R1上TELNET R3

    r1#telnet 192.168.1.3

    Trying 192.168.1.3 ... Open

    User Access Verification

    Password:

    r3>

    从R3上TELNET R1

    r3#telnet 172.16.1.1

    Trying 172.16.1.1 ...

    % Destination unreachable; gateway or host down

    第四步:

    从R1上ping R2直连接口

    r1#ping 172.16.1.2

    Type escape sequence to abort.

    Sending 5, 100-byte ICMP Echos to 172.16.1.2, timeout is 2 seconds:

    !!!!!

    Success rate is 100 percent (5/5), round-trip min/avg/max = 28/54/92 ms

    从R2上ping R1直连接口

    r2#ping 172.16.1.1

    Type escape sequence to abort.

    Sending 5, 100-byte ICMP Echos to 172.16.1.1, timeout is 2 seconds:

    !!!!!

    Success rate is 100 percent (5/5), round-trip min/avg/max = 16/67/124 ms

    从R2ping R3直连接口

    r2#ping

    *Mar 1 00:15:20.615: %SYS-5-CONFIG_I: Configured from console by console

    r2#ping 192.168.1.3

 

    Type escape sequence to abort.

    Sending 5, 100-byte ICMP Echos to 192.168.1.3, timeout is 2 seconds:

    *Mar 1 00:15:28.055: %SEC-6-IPACCESSLOGDP: list 100 denied icmp 192.168.1.3 -> 192.168.1.2 (0/0), 1 packet.....                //说明icmp包可以到达,但 是没有回包

    Success rate is 0 percent (0/5)

 

    从R3ing R2连接口

r3#ping 192.168.1.2

 

    Type escape sequence to abort.

    Sending 5, 100-byte ICMP Echos to 192.168.1.2, timeout is 2 seconds:

    U.U.U //说明icmp包不可以到达目的地

    Success rate is 0 percent (0/5)

 

 

    r1#ping 192.168.1.3

 

    Type escape sequence to abort.

    Sending 5, 100-byte ICMP Echos to 192.168.1.3, timeout is 2 seconds:

    !!!!!

    Success rate is 100 percent (5/5), round-trip min/avg/max = 76/124/156 ms

 

    r2#debug ip inspect icmp

    INSPECT ICMP Inspection debugging is on

    r2#

    *Mar 1 00:35:09.187: CBAC: ICMP Echo pkt 172.16.1.1 => 192.168.1.3

    *Mar 1 00:35:09.187: CBAC: ICMP Echo pkt 172.16.1.1 => 192.168.1.3

    *Mar 1 00:35:09.191: CBAC: ICMP Echo pkt 172.16.1.1 => 192.168.1.3

    *Mar 1 00:35:09.263: CBAC: ICMP Echo Reply pkt 192.168.1.3 => 172.16.1.1

    *Mar 1 00:35:09.375: CBAC: ICMP Echo pkt 172.16.1.1 => 192.168.1.3

    *Mar 1 00:35:09.423: CBAC: ICMP Echo Reply pkt 192.168.1.3 => 172.16.1.1

    *Mar 1 00:35:09.467: CBAC: ICMP Echo pkt 172.16.1.1 => 192.168.1.3

    *Mar 1 00:35:09.531: CBAC: ICMP Echo Reply pkt 192.168.1.3 => 172.16.1.1

    *Mar 1 00:35:09.563: CBAC: ICMP Echo pkt 172.16.1.1 => 192.168.1.3

    r2#

    *Mar 1 00:35:09.623: CBAC: ICMP Echo Reply pkt 192.168.1.3 => 172.16.1.1

    *Mar 1 00:35:09.671: CBAC: ICMP Echo pkt 172.16.1.1 => 192.168.1.3

    *Mar 1 00:35:09.735: CBAC: ICMP Echo Reply pkt 192.168.1.3 => 172.16.1.1

 

 

 

分享到您的社交平台:

发表评论:

请输入您的昵称!(必填)

正确格式为:http://www.rijiwang.com(选填)